Trophy Skin MicrodermMD

5 of 4 reviews

Step 1: Wash your face with a gentle cleanser and ensure it’s completely dry before using the MicrodermMD. Step 2: Plug into the wall so that the red LED light above the Power button comes on. Step 3: Remove the Diamond Tip and check that a clean black wool filter is in place on the end of the plastic wand, then push the Diamond Tip flush against the plastic wand so that there’s no visible gap between the two pieces. Step 4: Press the Power button so that you can hear the motor humming. Step 5: Select your Mode and then press the Start/Stop button. Step 6: Hold the wand like a pencil and press the Diamond Tip against your skin. Step 7: Using short, even strokes 2-3 inches long, glide the Diamond Tip across the skin’s surface (ensure the Diamond Tip is flush on the surface - you should feel a gentle suction.) Step 8: Follow the guide that’s displayed on the screen for the position and timing of the strokes along your face. Step 9: After your treatment, gently slide off the diamond tip to discard and replace the black wool filter - then clean the Diamond Tip with the included wire brush after every treatment. Step 10: Wash your face with cold water to remove any remaining debris, pat dry and then apply your favorite anti-aging serum immediately afterward.

If this product is sealed, please ensure the seal is intact prior to using the product.